bestbuildpc: Forums
 

Synology DS1512+ RAM Upgrade to 4GB
 
 
Post new topic   Reply to topic    bestbuildpc Forum Index -> Hardware/Overclocking
View previous topic :: View next topic  
Author Message
bestbuildpc
Site Admin
Site Admin


Joined: Jun 30, 2012
Posts: 167
Location: NL

PostPosted: Thu Nov 13, 2014 13:02    Post subject: Synology DS1512+ RAM Upgrade to 4GB Reply with quote

Upgrading your Synology DS1512+ to 4GB of RAM Maximum

1. Purchase compatible memory

http://www.newegg.com/Product/Product.aspx?Item=N82E16820145228










The first step in your Synology DS1512+ RAM Upgrade is to acquire a compatible RAM module.

Synology states the DS1512+ supports: 2GB -DDR3-1066 unbuffered So-DIMM 204pin CL=7 1.5V

Compatibility

http://forum.synology.com/wiki/index.php/User_Reported_Compatible_RAM_modules

2. Remove five screws from rear of DS1512+

Using a screwdriver, remove the five screws holding the cover panel in place on the rear side of the DS1512+.



Screw hole locations on rear of Synology DS1512+

3. Slide the cover panel off

Place your thumbs on the indicated positions and then slide the cover panel toward you to remove.




Rear view of Synology DS1512+

4. Gain Access to the expandable memory slot

Locate the expandable memory slot (pictured below)




Synology DS1512+ Expandable Memory Slot

5. Insert the RAM module into the expandable memory slot

Align the RAM module with the grooves of the memory slot. (It will only fit one way). You will need to insert the module at an angle (shown in the picture below).




Installing 2GB of RAM into Synology DS1512+ Memory Slot

6. Lock the RAM module in place

Slowly push the RAM module down until you hear a solid click. Note the two capture arms on both side should hold the RAM module in a locked position.




Synology DS1512+ Expandable Memory Slot with 2GB of RAM Installed

7. Reassemble your DS1512+

Reverse the above steps. Slide the cover panel back on and reinstall five screws to secure the cover panel

8. Power on and verify RAM upgrade

Power on your DS1512+. After a few moments you should hear a single beep indicating a successful boot. Log in to your DS1512+ and open System Information to verify that your new Synology DS1512+ RAM Upgrade is complete!
Back to top
Display posts from previous:       
Post new topic   Reply to topic    bestbuildpc Forum Index -> Hardware/Overclocking All times are GMT + 2 Hours
 
 Page 1 of 1

 

 Jump to:   
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum

 
Forums ©